Loading ...
Loading ...
Loading ...
SAFETY & AWARENESS
4
● There is a thermostat limiter inside the heater. When the inner temperature over heats
or abnormal heating occurs, the thermostat protective device will cut off power supply
to avoid risk of fire or damage to the heater.
● Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this
may cause an electric shock or fire, or damage the heater.
● To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use
on soft surfaces, like a bed, where opening may become blocked.
● The heater has hot and arcing or sparking parts inside. Do not use it in areas where
gasoline, paint or flammable liquids are used or stored.
● Use this heater only as described in the manual. Any other use not recommended by the
manufacturer may cause fire, electric shock or injury to persons.
● Always plug heaters directly into a wall outlet/receptacle. Never use with an extension
cord or relocatable power tap (outlet/ power strip).
● This heater is for use on 120 volts.
HEATER LOCATION
When choosing a location for your new heater, ensure that the general instructions are
followed. Also, for best effect, install the heater out of direct sunlight. Cold climate
installation recommendation: when installing this unit against a non-insulated exterior
wall or chase, it is mandatory that the outer walls be insulated to conform to applicable
insulation codes.
ELECTRICAL CONNECTION
A 15 AMP, 120 Volt, 60 Hz circuit with a properly grounded outlet is required. Preferably,
the heater will be on a dedicated circuit as other appliances on the same circuit may cause
the circuit breaker to trip or the fuse to blow when the heater is in operation.
CAUTION: Do not exceed the current rating of the current tap. Always plug heaters directly
into a wall outlet/receptacle. Never use with an extension cord or relocatable power tap
(outlet/ power strip).
CLEARANCE TO COMBUSTIBLES
Keep electrical cords, drapery, furniture and other combustibles at least 3 feet (0.6 m) from
the front of the heater and away from the sides.
SAFETY & AWARENESS
5
MAINTENANCE
WARNING: Make sure the power is turned off before proceeding. Any electrical repairs
or rewiring of this unit should be carried out by a licensed electrician in accordance with
national and local codes.
If repairing or replacing any electrical component or wiring, the original wire routing, color
coding and securing locations must be followed.
WARNING: Electrical outlet wiring must comply with local building codes and other
applicable regulations to reduce the risk of fire, electrical shock and injury to persons.
WARNING: Do not use this heater if any part of it has been under water. Immediately call
a qualified service technician to inspect the heater and replace any part of the electrical
system.
Warning: Disconnect power before attempting any maintenance or cleaning to reduce the
risk of fire, electrical shock or personal injury.
Warning: During any service of this appliance, the power to the unit must be turned off.
First turn the main power switch to the “OFF” position, wait for the fan to stop blowing to
ensure the inside of the heater has been properly cooled. Then remove the electrical plug
from the wall outlet.
Loading ...
Loading ...
Loading ...