Loading ...
Loading ...
Loading ...
GB - 20
10
REPLACING THE OVEN LAMP (g. 11-12)
Ensure the appliance is switched off before
replacing the lamp to avoid the possibility of
electric shock..
IIn the event one or both oven lamps need replacing,
the new lamps must comply with the following
requisites:
15 W - 230 V~ - 50 Hz - E 14 - and must be resistant
to high temperature (300°C).
The appliance can have two different types of lamp
holder:
• Lamp holder type 1 (g. 11): Draw out the side
guide rails as described above.Then, remove the
glass protection cap (V) from the bulb socket, lifting
it with a screwdriver placed between the cap and
the oven wall and replace the lamp (L). Fit the
accessories back in reverse order.
• Lamp holder type 2 (g. 12): Turn glass protection
cap (C) counterclockwise and change the lamp.
Re-t the cap, screwing it back in a clockwise
direction.
11
11A
OVEN CAVITY
The oven cavity should be cleaned after each use
to remove cooking residuals and or grease or sugar
which, if burnt on when the oven is used again, will
form deposits or unremovable stains as well as
unpleasant smells.
To maintain the shine of the enamelled parts, clean
them with warm soapy water, rinse and dry them
thoroughly. ALWAYS wash the accessories used.
OVEN SEAL
The oven seal guarantees the correct functioning of
the oven. We recommend you:
• clean it, avoiding abrasive tools or products.
• check its state now and then.
If the oven door seal has become hard or is damaged,
contact our Service Centre and avoid using the oven
until it has been repaired.
OVEN SIDEWALL GRIDS (g. 10)
To allow for a better cleaning of the side grids, you can
extract them this way:
1. Push with a nger on the last of the slots to release
the grid from its hold.
2. Lift it towards the top and extract the grid.
To put them back into place, reverse the order of this
operation.
INSTRUCTIONS FOR THE USER
Loading ...
Loading ...
Loading ...