Loading ...
Loading ...
Loading ...
CONNECTING THE WATERLINE
33
1
Vertical Cold
Saddle-Type
Pipe Clamp
Water pipe
(CONTINUED)
Washer
Inlet End
Pipe Clamp
Clamp Screw
Packing Nut
Oulet Valve
Ferule (sleeve)
Compression Nut
2. SELECT THE LOCATION OF THE VALVE.
Select the location of the valve that will
provide a better access. It is best to connect
to a vertical pipeline. When connecting to a
horizontal pipeline is necessary, make the
connection in the lateral or upper area
instead of the lower area to prevent
accumulation of sediment.
3. DRILL A HOLE FOR THE VALVE.
Drill a ¼”(6,35 mm) diameter hole in the water
pipeline. Remove jagged edges produces after
perforation. Make sure water does not reach
the drill. Not performing the ¼”(6,35 mm)
perforation can lead to a low or smaller ice
production.
4. Tighten the valve.
Tight the valve into the cold water pipeline with a tube trap.
Shutoff valve
NOTE: Codes for 248 CMR pipelines of the state of
Massachusetts must be attached to the connection.
Valves of this type are banned in Massachusetts.
Call an authorized plumber.
5. TIGHTEN THE TRAP.
Tighten the trap until the sealing ring begins to grow.
NOTE: Make sure it is not too tight, this can break the pipe.
6. PLACE THE PIPELINE.
Place the pipeline between the cold water pipe and the
refrigerator. Place it through a hole in the wall or floor
(behind the refrigerator or next to the cabinet) as close
to the wall as possible.
NOTE: Make sure there is a sufficient amount of extra
pipeline (8 feet [244 mm] coiled up three times with a
10” [25 cm] in diameter) to allow free movement of the
refrigerator from the wall after installation was made.
7. CONNECT PIPELINE TO VALVE
Place the compression nut and the copper pipe ferule
at the end of the pipe and connect to the valve. Make
sure the pipe is completely inserted into the valve.
Tighten nut carefully.
Saddle-Type
Shutoff valve
NOTE: Codes for 248 CMR pipelines of the state of
Massachusetts must be attached to the connection.
Valves of this type are banned in Massachusetts.
Call an authorized plumber.
8. DRAIN THE PIPE.
Open the main water source (1) and drain the pipe
until water comes out clear.
INSTALLATION INSTRUCTIONS
Loading ...
Loading ...
Loading ...