Loading ...
Loading ...
Loading ...
REFRIGERATOR INSTALLATION
Open both doors again and check to make sure that
they close easily. If not, slightly tilt the refrigerator
further back by turning both leveling screws clockwise.
It may take several more turns. Make sure that you
turn both leveling screws the same amount.
CLOSING AND ALIGNING THE DOORS
Closing the Doors
Your refrigerator has two front leveling screws, one on the
right and one on the left. If your refrigerator seems unstable
or if you would like the doors to close more easily, simply
adjust the inclination of the refrigerator by following the
1. Plug the refrigerator into a 3 prong grounded outlet.
Move the refrigerator into its final position.
2. Remove the base grill (Refer to the section on
“Installing the Base Grill”).
Use a flat head screwdriver to adjust the leveling screws,
turning clockwise to raise the side of the refrigerator and
counter-clockwise to lower it. It may take several turns to
NOTE: Having someone push against the top of the
refrigerator takes some weight off the leveling screws.
This will make it easier to adjust the screws.
3.
4. Ensure that the refrigerator is even by using a level.
5. Replace the base grill.
Aligning the Doors
If the spacing between the doors is uneven, follow the
instructions below to align them:
1. Pry off the top hinge cover.
2. Loosen the screws from the top hinge using a 10mm
socket or wrench.
3. Have someone help you hold the door in place or
place a spacer between the doors while tightening
the top hinge screws.
4. Replace the top hinge cover.
AFTER COMPLETING INSTALLATION
Make sure that the corners of the door seals are not f
olded over. To ensure a good seal, apply a little silicon .
grease on them.
20
Corners
Corners
instructions below:
3.
adjust it to the inclination you would like.
Loading ...
Loading ...
Loading ...