Loading ...
Loading ...
Loading ...
19
TECHNICAL DATA
Voltage: 120 V~ 60 Hz max. 10A
Absorbed power: 1250W
Pressure: 15 bar
Max. water tank capacity: 1.8 litres
Size: LxHxD: 238x351x430 mm
Cable length: 1,75 m
Weight: 9.1 kg
Max. beans container capacity: 250 g
DISPLAYED MESSAGES
MESSAGE DISPLAYED POSSIBLE CAUSE SOLUTION
FILL TANK Insucient water in the tank. Fill the tank with water and/or insert it correctly, pushing
it as far as it will go until it clicks into place (g. 4).
EMPTY GROUNDS CONTAINER The grounds container (A14) is full. Empty the grounds container and drip tray, clean and
replace (g. 23). Important: When removing the drip
tray, the grounds container must be emptied, even if it
contains few grounds. If this is not done, when you make
the next coees, the grounds container may ll up more
than expected and clog the machine.
GROUND TOO FINE ADJUST
MILL
The grinding is too ne and the
coee is delivered too slowly or not
at all.
Repeat coee delivery and turn the grinding adjustment
dial (g. 11) one click clockwise towards “7” while the
coee mill is in operation.If after making at least 2 cof-
fees delivery is still too slow, repeat the correction proce-
dure, turning the grinding adjustment dial another click
until delivery is correct (see the grinding adjustment
section on page 12) If the problem persists, make sure
the water tank is fully inserted, press the
button and
deliver a little water from the spout.
INSERT GROUNDS CONTAINER After cleaning, the grounds contai-
ner has not been replaced.
Remove the drip tray and insert the grounds container.
ADD PREGROUND COFFEE With the pre-ground function selec-
ted, pre-ground coee has not been
poured into the funnel.
Add pre-ground coee in the funnel or deselect the pre-
ground function.
DESCALE The machine must be descaled. The descaling procedure described in the section “Desca-
ling” needs to be performed as soon as possible (page
17).
LESS COFFEE Too much coee has been used. Select a milder avour or reduce the quantity of pre-
ground coee.
FILL BEANS CONTAINER The coee beans have run out. Fill the beans container.
The pre-ground coee funnel is
clogged.
Empty the funnel with the help of a brush as described in
the section “Cleaning the pre-ground coee funnel”.
INSERT INFUSER ASSEMBLY The infuser has not been replaced
after cleaning.
Insert the infuser as described in the paragraph “Cleaning
the infuser” (page 16).
INSERT TANK The tank was not inserted properly. Insert the tank correctly and press as far as it will go.
GENERAL ALARM The inside of the appliance is very
dirty.
Clean the inside of the appliance thoroughly, as descri-
bed in the section “Cleaning” (page 15). If the message is
still displayed after cleaning, contact a service centre.
Loading ...
Loading ...
Loading ...