Loading ...
Loading ...
Loading ...
13
coee is prepared.
Once the coee has been made, the appliance is ready to make
the next drink.
Please note :
While the appliance is making coee, the ow can be inter-
rupted at any moment by pressing any button.
• At the end of delivery, to increase the quantity of coee
in the cup, just press and hold one of the coee buttons
(within 3 seconds) ( or ).
Please note :
For hotter coee, consult the paragraph "Tips for a hotter cof-
fee“.
Important!
• If the coee is delivered a drop at a time, too weak and not
creamy enough or too cold, read the tips in the “Trouble-
shooting” section on page 20.
• Various alarm messages could be displayed while using the
machine (FILL TANK, EMPTY GROUNDS CONTAINER, etc).
Their meaning is explained in the section “Displayed mes-
sages” (page 19).
Making coee using pre-ground coee
Important!
• Never place coee beans in the pre-ground coee funnel
as this could damage the appliance.
• Never add pre-ground coee when the machine is o or it
could spread through the inside of the machine and dirty
it. This could damage the appliance.
• Never use more than one level
measure or it could dirty the in-
side of the machine or block the
funnel.
Please note :
When you use pre-ground coee, you can only make one cup of
coee at a time.
1. Make sure the appliance is on.
2. Press the dial
(g. 7) repeatedly until “Pre-
ground” is displayed.
3. Make sure the funnel is not blocked, then add one level
measure of pre-ground coee (g. 15).
4. Place a cup under the coee spouts.
5. Press the 1 cup dispensing button .
6. The preparation starts and the display shows the coee
selected and a progression bar that lls gradually as the
coee is prepared.
Please note:
If “Energy Saving” mode is enabled, you may have to wait a few
seconds before the rst cappuccino is dispensed.
MAKING CAPPUCCINO AND MILK BASED
COFFEES
Please note:
• To avoid producing milk with poor froth or large bubbles,
always clean the milk container lid and hot water connec-
tion nozzle as described in the section “Cleaning the milk
container” on pages 14 and 16.
Filling and attaching the milk container
1. Remove the lid (g. 16);
2. Fill the milk container with a sucient quantity of milk,
not exceeding the MAX level marked on the handle (g.
17). Each mark on the side of the container corresponds to
100 ml of milk.
Please note:
• For a denser more even froth, you must use skimmed or
partially skimmed milk at refrigerator temperature (about
5°C).
If “energy saving” mode is enabled, you may have to wait a
few seconds before the rst cappuccino is delivered.
3. Make sure the milk intake tube is correctly inserted in the
bottom of the milk container lid (g. 18).
4. Attach the lid back on the milk container.
5. Attach the container to the connection nozzle and push as
far as it will go (g. 19). The machine emits a beep.
6. Place a suciently large cup under the coee and frothed
milk spouts. Adjust the length of the milk spout. To move it
nearer the cup, simply pull it downwards (g. 20).
7. Follow the instructions below for each function.
Adjusting the amount of froth
Turn the froth adjustment dial on the milk container lid to adjust
the amount of froth on the milk delivered while making milk
drinks (g. 21). Follow the tips in the table below:
Dial
position
Description Recommended for…
No froth CAFFELATTE /
MILK (hot milk)
Min. froth LATTE MACCHIATO /
FLAT WHITE
Max. froth CAPPUCCINO /
MILK frothy milk
Loading ...
Loading ...
Loading ...