Loading ...
Loading ...
Loading ...
Installation
52
5.4 Fixing to the supporting structure
Secure the hob to the piece of furniture
through the appropriate bracket (A).
The figure below shows the fastening points
of the cover to the top surface.
5.5 Gas connection
General information
Connection to the gas mains can be made
using a rigid copper pipe or a continuous
wall steel hose in compliance with the
provisions established by the applicable
standard. The appliance is preset for natural
gas G20 (2H) at a pressure of 20 mbar.
For supplying it with other types of gas, see
chapter “5.6 Adaptation to different types
of gas”. The gas inlet connection is
threaded ½” external gas (ISO 228-1).
Do not fix the hob using silicone.
This would make it impossible to
remove the hob, if necessary,
without damaging it.
Gas leak
Danger of explosion
• After carrying out any operation, check
that the tightening torque of gas
connections is between 10 Nm and
15 Nm.
• If required, use a pressure regulator that
complies with current regulations.
• At the end of the installation, check for
any leaks with a soapy solution, never
with a flame.
• The hoses should not come into contact
with moving parts and should not be
crushed in any way.
• The adjustment conditions for this
appliance are shown on the gas setting
label.
Loading ...
Loading ...
Loading ...