Loading ...
Loading ...
Loading ...
Installation
51
EN
opens on rear
Hob seal
To prevent leakage of liquid between the
frame of the hob and the work surface,
place the insulating seal provided in
position before assembly, as shown in the
figure below.
1. Refer to the dimensions in the figure,
bearing in mind that the front and rear
sides of the seal must brush against the
hole.
2. Use light pressure to make the seal stick
to the edge around the hole cut in the
worktop.
3. Carefully trim the surplus away from
edge (C) beyond the seal.
Failure to install the double-layer
wooden base exposes the user to
possible accidental contact with
sharp or hot parts.
The dimensions given in this
drawing refer from the hole to the
inside of the seal.
Loading ...
Loading ...
Loading ...