Loading ...
Loading ...
Loading ...
22
RESET THE DOOR HINGE
1. Lift the door from the bottom hinge pin and place it on a flat
surface.
2. Using a driver with a #2 square bit, remove the bottom hinge
with the bushing from the cabinet.
A. Bushing B. Hinge base
3. Insert the bottom hinge and bushing into the corresponding
slot in the bottom of the door.
NOTE: Make sure that the base of the hinge is parallel to the
bottom of the door.
A. Hinge base parallel to the bottom edge of the door
4. Turn the hinge until the hinge base is at a 90° angle to the
bottom edge of the door.
A. Hinge base turned to a 90° angle with the bottom edge of
the door
5. Remove the hinge from the door. Reattach the bottom hinge to
the refrigerator cabinet.
6. The hinge is now reset and prepared for the door to be
replaced.
Replace Refrigerator Doors and
Hinges
Replace Right-Hand Refrigerator Door
1. Set the right-hand door onto the bottom hinge pin.
2. Insert the top hinge pin into the open hole in the top of the
refrigerator door.
3. Fasten the hinge to the cabinet. Do not tighten the screws
completely.
Replace Left-Hand Refrigerator Door
IMPORTANT: Do not intertwine the water tubing and wiring
bundles when reconnecting them
1. Set the left-hand door onto the bottom hinge pin.
2. Fasten the hinge to the cabinet. Do not tighten the screws
completely.
3. If applicable, reconnect the water dispenser tubing.
Style 1 - Insert the tubing into the fitting until it stops and the
outer ring is touching the face of fitting.
Style 2 - Insert the tubing firmly into the fitting until it stops.
Close the clasp around the tubing. The clasp snaps into place
between the fitting and the collar.
4. Reconnect the electrical wiring.
� Push together the two sections of the wiring plug.
Final Steps
1. Completely tighten the internal screws
2. Replace both top hinge covers.
Remove and Replace Refrigerator
Drawer
Depending on the width of your door opening, it may be necessary
to remove the drawer fronts to move the refrigerator into your
home.
REMOVE DRAWER FRONT
IMPORTANT:
� If the refrigerator was previously installed and you are moving
it out of the home, before you begin, turn the refrigerator
control Off, and unplug the refrigerator or disconnect power.
Remove food and any adjustable door or utility bins from
doors.
� Two people may be required to remove and replace the
freezer drawer. Graphics are included later in this section.
Tools Needed: 1/4" Hex head nut driver, Flat-blade screwdriver
Disconnect Wiring (if applicable)
NOTES:
� The exterior refrigerator drawer front is connected to the
temperature control on some models. Before removing the
drawer front, the wires must be disconnected from the
temperature control.
� The gray cable visible behind and under the pantry drawer at
the right side contains wiring for the pantry control and moves
with the drawer as it is pulled out. There is no need to
disconnect this cable.
Loading ...
Loading ...
Loading ...