Loading ...
Loading ...
Loading ...
16
FILTERS AND ACCESSORIES
Water Filtration System
Install the Water Filter
1. Locate the accessory packet in the refrigerator and remove
the water lter.
2. Take the water lter out of its packaging and remove the cover
from the O-rings. Be sure the O-rings are still in place after the
cover is removed.
3. The water lter compartment is located in the right-hand side
of the refrigerator ceiling. Push up on the compartment door
to release the catch, and then lower the door.
4. Align the arrow on the water lter label with the cutout notch
in the lter housing, and insert the lter into the housing.
5. Turn the lter clockwise 90 degrees (1/4 turn), until it locks
into the housing.
NOTE: If the lter is not correctly locked into the housing, the
water dispenser will not operate. Water will not ow from the
dispenser.
6. While the compartment door is still open, lift the lter up into
the compartment. Then, close the lter compartment door
completely.
7. Flush the water system. See “Flushing the Water Filter” in the
“Water and Ice Dispensers” section.
IMPORTANT: If you do not ush the water system, you may
experience dripping and/or decreased ow from the water
dispenser.
The Water Filter Status Light
Press WATER FILTER to display the percentage of lter life
remaining (from 99% to 0%). Press WATER FILTER again to return
to the Normal screen.
The water lter status lights will help you know when to change
your water lter.
ORDER (yellow) - it is almost time to change the water lter.
REPLACE (red) - Replace the water lter. While you are
dispensing water, “Replace” will blink.
NOTE: If a water lter is not installed or is undetected
because it is not properly installed (locked into place),
“Replace” and “--% remaining” will display on the control
panel. Check the water lter.
RESET the water lter status tracking feature. After you
replace the disposable water lter with a new lter, closing the
lter compartment door will automatically reset the lter status
tracking feature. See “Using the Controls.”
NOTE: “Replace” will remain illuminated if a lter is not
installed or is installed incorrectly.
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
B
A
A. O-ring cover
B. O-rings
Accessories
Loading ...
Loading ...
Loading ...