Loading ...
Loading ...
Loading ...
50
5 Maintenance
Precondition:The start screen is displayed.
T Press the
‘P’ button for approximately
2 seconds to enter programming mode.
T Press the
‘`’ button.
T Press the
‘Machine settings’ button.
T Press the
‘`’ button several times until page
‘3/5’ is displayed.
T Press the
‘Water hardness’ button.
‘Water hardness’
T Press the ‘<’ or ‘>’ button to change the
setting.
T Press the
‘Save’ button.
‘Saved’ appears briefly on the display.
‘Machine settings’
T Press the ‘Back’ button for approximately
2 seconds to return to the start screen.
Language
In this programme item you can set the language
used by your ENA.
Example:Proceed as follows to change the
language from
‘English’ to ‘Deutsch’.
Precondition:The start screen is displayed.
T Press the
‘P’ button for approximately
2 seconds to enter programming mode.
T Press the
‘`’ button.
T Press the
‘Machine settings’ button.
T Press the
‘`’ button several times until page
‘3/5’ is displayed.
T Press the
‘Choose language’ button.
‘Choose language’
T Press the ‘Deutsch’ button.
‘Gespeichert’ appears briefly on the display.
‘Geräteeinstellungen’
T Press the ‘Zurück’ button for approximately
2 seconds to return to the start screen.
5 Maintenance
Your ENA has the following integrated mainte-
nance programmes:
U
Rinsing the machine (‘Rinse’)
U
Cleaning the milk system (‘Clean the milk
system’
)
U
Changing the filter (only if filter is fitted)
U
Cleaning the machine (‘Clean’)
U
Descaling the machine (‘Descale’)
E Clean the machine, descale the machine or
change the filter when you are prompted to
do so.
E In the programme item
‘Maintenance status’
you will find an overview of the maintenance
programmes. When the bar is completely
filled with red, your ENA will prompt you to
perform the appropriate maintenance
programme.
E In the interests of hygiene, you should clean
the milk system daily when you have been
preparing milk.
Rinsing the machine
You can initiate the rinse operation manually at
any time.
Precondition:The start screen is displayed.
T Place a receptacle under the dual spout.
T Press the
‘P’ button for approximately
2 seconds to enter programming mode.
T Press the
‘Maintenance status’ button.
T Press the
‘`’ button several times until page
‘3/3’ is displayed.
Loading ...
Loading ...
Loading ...