Loading ...
Loading ...
Loading ...
44
2 Preparation
T Press the ‘Latte macchiato’ button.
‘Latte macchiato’, the preset amount of milk
foam flows into the glass.
E There is a short interval while the hot milk
separates from the milk foam. This allows
the typical layers of a latte macchiato to
form.
Coffee preparation starts. The preset
amount of water for espresso flows into the
glass. Preparation stops automatically.
Your ENA is once more ready for use.
E 15 minutes after preparation, the milk
system is automatically rinsed (see
Chapter 5 ‘Maintenance – Automatic milk
system rinsing’). Therefore always place a
receptacle under the dual spout after
preparing milk.
To ensure that the milk system in the dual spout
always works properly, you must clean it daily
(see Chapter 5 ‘Maintenance – Cleaning the milk
system’).
Ground coffee
You can choose to use a second coffee variety, for
example decaffeinated coffee, with the filter funnel
for ground coffee.
Basic information about ground coffee:
U
Never add more than one level measuring
spoon of ground coffee.
U
Use ground coffee which is not ground too
finely. Very fine coffee can block up the system
so that the coffee only comes out in drips.
U
If you did not fill the machine with a sufficient
amount of ground coffee,
‘Not enough ground
coffee’
is displayed and the ENA stops the
operation.
U
The desired speciality coffee must be prepared
within approximately one minute after filling
with the ground coffee. Otherwise the ENA
stops the operation and is once more ready for
use.
All speciality coffees with ground coffee are always
prepared following the same model.
Example:Proceed as follows to prepare one
espresso using ground coffee.
Precondition:The start screen is displayed.
T Place an espresso cup under the coffee
spout.
T Open the powder chute for ground coffee.
‘Ground coffee’ / ‘Please add ground coffee’
T Fit the filler funnel for ground coffee.
T Place one level measuring spoon of ground
coffee into the filler funnel.
T Remove the filler funnel and close the cover
of the powder chute.
T Press the
‘Espresso’ button.
Preparation starts.
‘Espresso’, the preset
amount of water for espresso flows into the
cup.
Preparation stops automatically. Your ENA is
once more ready for use.
Loading ...
Loading ...
Loading ...