Loading ...
Loading ...
Loading ...
6
STEAM IRONING
1. Steam is available when the temperature control is at S or above.
2. Set the steam control to S .
3. Wait till the light goes off, then start ironing.
SPRAY
Water spotting can affect some fabrics. Test this out on a hidden part of the fabric.
1. Lift the iron off the fabric.
2. Aim the spray nozzle at the fabric.
3. Press the * button – you may have to press it 2 or 3 times to pump water
through the system.
DRY IRONING
1. Set the steam control to
S
.
2. Wait until the light goes off then start ironing.
• If you’re going to be dry ironing for 20 minutes or more, empty the iron
reservoir first, to avoid spontaneous bursts of steam.
AFTER USE
1. Set the temperature control to • set the steam control to
S
.
2. Unplug the iron.
3. Raise the side of the water inlet cover to open it.
4. Hold the iron over a sink, turn it upside down, and drain the water from the
reservoir.
5. Sit the iron on its heel, and leave it to cool down completely.
6. When cold, wipe off any moisture, and close the water inlet cover.
7. Wipe outer surfaces with a damp cloth.
8. Remove spots from the soleplate with a little vinegar – take care not to scratch it.
9. Store the iron on its heel, to avoid corrosion and damage to the soleplate.
DESCALING
As you may be using the iron in areas where you don’t know whether the water is
soft or hard, we suggest that you carry out this procedure fortnightly, or at the end of
each trip, if the trips are shorter than a fortnight. It only takes a few minutes.
1. Half fill the reservoir with water.
2. Turn the steam control to
S
, turn the temperature control to max.
3. Plug the iron into the power socket, and wait for the ready light to go out.
4. When the ready light goes out, unplug the iron.
Loading ...
Loading ...