Loading ...
Loading ...
Loading ...
TurboLock TL - 201 17
4.2 Main Installation
Step 1. Start with the outside section. Feed the power cables under the latch and
thread the latch pin and two of the pegs through the latch; the third and
lowest peg should be under the latch. If needed, have someone hold the door
itself or hold the outside section at against the front of the door. (Fig. 10)
• Before threading the latch pin into the silver center part , make sure the key is
turned so it can easily be removed from the keyhole. Make sure the latch pin is
horizontal when inserting.
• It’s highly recommended to leave the door open and keep the keys in the lock
during installation.
• Make sure the power cables are under the latch.
Step 2. Align the plate on the back of the door while making sure to thread the
cables under the latch. Move the cables to the corner opening of the plate.
Thread the latch pin through the larger hole and match up the pegs with the smaller surrounding holes. Use the 3x
mounting screws to fasten the plate to the back of the door. Make sure all screws are tightened. (Fig. 11)
• Check and adjust the plate or cables
as needed to make sure the cables
are tucked under the latch. Do NOT
force the screw through the cables as
this will damage the lock and/or make
it unusable.
2
3/4
”
2
3/8
”
Silicone Backing
2
3/4
”
2
3/8
”
2
3/4
”
70
60
2
3/8
”
2
3/4
”
2
3/8
”
2
3/4
”
70
60
2
3/8
”
2
3/4
”
2
3/8
”
(Fig. 10)
(Fig. 11)
Latch Pin
Loading ...
Loading ...
Loading ...