Loading ...
Loading ...
Loading ...
Installation Requirements
Exhaust system requirements, continued
Install male fittings in correct direction:
CORRECT iNCORRECT
In installations where the exhaust system is not described
in previous pages, the following method must be used to
determine if the exhaust system is acceptable:
1 Connect an inclined or digital manometer between
the dryer and the point the exhaust connects to the
dryer.
2 Set the dryer timer and temperature to air fluff and
start the dryer.
3 Read the measurement on the manometer.
4 The system back pressure MUST NOT be higher
than 0.6 inches of water column. If the system back
pressure is less than 0.6 inches of water column, the
system is acceptable. If the manometer reading is
higher than 0.6 inches of water column, the system
is too restrictive and the installation is unacceptable.
Although vertical orientation of the exhaust system is
acceptable, certain extenuating circumstances could affect
the performance of the dryer:
° Only rigid metal duct work should be used.
° Venting vertically through a roof may expose the
exhaust system to down drafts causing an increase
in vent restriction.
° Running the exhaust system through an uninsulated
area may cause condensation and faster
accumulation of lint.
° Compression or crimping of the exhaust system wiii
cause an increase in vent restriction.
° The exhaust system should be inspected and
cleaned a minimum of every 18 months with normal
usage. The more the dryer is used, the more often
you should check the exhaust system and vent hood
for proper operation.
Exhaust direction
The laundry center may be exhausted four (4) ways with
rear flush installation:
1. Straight back
2.
.
4.
Down (8 inch [20.3 cm] length of 4 inch diameter [102
mm] rigid duct and 1 elbow down)
Left (8 inch [20.3 cm] length of 4 inch diameter [102
mm] rigid duct, 1 elbow down and 1 elbow left)
Right (8 inch [20.3 cm] length of 4 inch diameter [102
mm] rigid duct, 1 elbow down and 1 elbow right)
To exhaust up, add an 11inch (28 cm) length of standard
4 inch (102 mm) diameter duct and a 90 ° elbow. The unit
will be positioned about 4.5 inches (11.5 cm) away from
the wail (flush to wail exhausting may be done by going
below the dryer then sideways).
An exhaust hood positioned to line up with the dryer
exhaust can be installed directly through the outside wall.
To exhaust to the side or down, add an 8 inch (20.3 cm)
length of standard 4 inch (102 mm) diameter duct and a
90 ° elbow.
See also Clearance Requirements on the next page.
Loading ...
Loading ...
Loading ...