Loading ...
Loading ...
Loading ...
installation Instructions
Leveling your laundr V center
Excessive noise and vibration can be prevented by
properly leveling the laundry center.
| With the laundry center within 4 feet (1 m) of its
final location, place a level on top of the washer lid.
2 Use adjustable pliers to adjust the leveling legs so
the laundry center is level front-to-rear and side-to-
side, and stable corner-to-corner.
3 Press down on alternate corners and sides and feel
for the slightest movement. Adjust the appropriate
leg(s) so the laundry center sits solidly on the floor
on ALL four legs. Keep the leveling leg extension at
a minimum for best performance of the washer.
Connecting inlet water
| Run some water from the hot and cold faucets to
flush the water lines and remove particles that might
clog the water valve screens and to determine which
faucet is hot and which is cold supply.
RUBBER WASHERS "_ ",
MUST BE PRESENT
USEONLY
NEW HOSES
Hoses are not included with laundry center purchase.
See"Accessories"sectionforvariousinlethosekitstofit
your specific installation.
2 Connect the HOT inlet hose to the HOT inlet
connection on the washer and the COLD inlet
hose to the COLD inlet connection on the washen
Tighten by hand until snug. Then tighten each supply
connection another 2/3 turn with pliers. Do not cross
thread or over-tlghfen these connectlons.
3 Connect the HOT inlet hose to the HOT water supply
and the COLD inlet hose to the COLD water supply.
Tighten by hand until snug. Then tighten each supply
connection another 2/3 turn with pliers. Do not
bend, kink or pinch water inlet hoses.
4 Turn on the water and check for leaks.
i
[HOT)
g
r
b
/
\
J
\
17
Loading ...
Loading ...
Loading ...