Loading ...
Loading ...
Loading ...
HOB - DAILY USE
WARNING! Refer to Safety chapters.
IGNITION OF THE HOB BURNERS
Always light the burner before you put
on the cookware.
WARNING! Be very careful when you
use open fire in the kitchen
environment. The manufacturer
declines any responsibility in case of
the flame misuse.
1. Turn the knob for the hob to the position
and push it down. When you push the knob,
the spark generator activates automatically.
2. Keep the knob for the hob pushed for equal or
less than 10 seconds to let the thermocouple
warm up. If not, the gas supply is interrupted.
3. Adjust the flame after it is regular.
WARNING! Do not keep the knob
pushed for more than 10 seconds. If
the burner does not light after 10
seconds, release the knob, turn it into
the off position and try to light the
burner again after minimum 1 minute.
If after some tries the burner does not
light, check if the crown and its cap
are in the correct position.
In the absence of electricity you can
ignite the burner without an electrical
device. In this case approach the
burner with a flame, push the relevant
knob down and turn it to maximum
position. Keep the knob pushed for
equal or less than 10 seconds to let
the thermocouple warm up.
If the burner accidentally goes out,
turn the knob to the off position and try
to light the burner again after minimum
1 minute.
The spark generator can start
automatically when you switch on the
mains, after installation or a power cut.
It is normal.
BURNER OVERVIEW
A
B
C
G
F
E
D
A. Burner cap
B. Burner crown
C. Slots
D. Thermocouple
E. Ignition candle
F. Burner body
G. Hole for the ignition candle
REPLACING BURNER PARTS
1. Put carefully the burner crown on the burner
body. Let the crown fall freely onto the body.
Do not use force.
Make sure that the hole in the crown is above
the ignition candle.
Make sure that the location pegs are in the
slots in the burner body.
8
Loading ...
Loading ...
Loading ...