Loading ...
Loading ...
Loading ...
91
MAINTENANCE
Battery
Battery Charging
The following battery charging instructions apply only to the
installation of a sealed battery. Read all instructions before proceeding
with the installation of this battery.
The sealed battery is already filled with electrolyte and has been
sealed and fully charged at the factory. Never pry the sealing strip off
or add any other fluid to this battery.
The single most important thing about maintaining a sealed battery is
to keep it fully charged. Since the battery is sealed and the sealing strip
cannot be removed, you must use a voltmeter or multimeter to
measure DC voltage.
An overheated battery may explode, causing severe injury or death.
Always watch charging times carefully. Stop charging if the battery
becomes very warm to the touch. Allow it to cool before resuming
charging.
For a refresh charge, follow all instructions carefully.
1. Check the battery voltage with a voltmeter or multimeter. A fully
charged battery will register 12.8 V or higher.
2. If the voltage is less than 12.8 volts, recharge the battery at 1.2
amps or less until battery voltage is 12.8 or greater.
Tip: When using an automatic charger, refer to the charger manufacturer's
instructions for recharging. When using a constant current charger, use
the guidelines on the next page for recharging.
Loading ...
Loading ...
Loading ...