Loading ...
Loading ...
Loading ...
• Rear ParkSense Chime Volume
The Rear ParkSense Chime Volume settings can be selected
from the EVIC/DID or Uconnect System — if equipped. The
chime volume settings include LOW, MEDIUM, and HIGH.
The factory default volume setting is MEDIUM. To change
the mode status, press the “Rear ParkSense Volume” button
and select the “Low” “Med” or “High” buttons on the
touchscreen. ParkSense will retain its last known configura-
tion state through ignition cycles.
• Tilt Side Mirrors In Reverse — If Equipped
When this feature is selected, the outside sideview mir-
rors will tilt downward when the ignition is in the RUN
position and the transmission gear selector is in the
REVERSE position. The mirrors will move back to their
previous position when the transmission is shifted out of
REVERSE. To make your selection, press the “Tilt Side
Mirrors In Reverse” button on the touchscreen to select
from on or off.
• ParkView Backup Camera
Your vehicle may be equipped with the ParkView Rear
Back Up Camera that allows you to see an on-screen
image of the rear surroundings of your vehicle whenever
the gear selector is put into REVERSE. The image will be
displayed on the radio touchscreen display along with a
caution note to “check entire surroundings” across the
top of the screen. After five seconds, this note will
disappear. The ParkView camera is located on the rear of
the vehicle above the rear License plate. To make your
selection, press the “ParkView Backup Camera” button
on the touchscreen, until a check-mark appears next to
the setting, indicating that the setting had been selected.
• ParkView Backup Camera Active Guidelines
Your vehicle may be equipped with the ParkView Rear
Back Up Camera Active Guidelines that allows you to see
Active (Dynamic) Guidelines which deflect with steering
wheel angle over the ParkView Back up Camera display
404 UNDERSTANDING YOUR INSTRUMENT PANEL
Loading ...
Loading ...
Loading ...