Loading ...
Loading ...
Loading ...
5
Water Filtration System
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Water Filter Status Light
The filter status light will help you know when to change your
water filter.
J It is recommended that you replace the filter when the status
light changes to red OR water flow to your water dispenser or ice
maker decreases noticeably.
NOTE: The filter should be replaced at least every six months
depending on your water quality and usage.
Resetting the Filter Status
J After changing the filter, reset the filter status light by pressing and
holding LIGHT and ICE TYPE for 3 seconds.
The status light will turn off when the system is reset.
Changing the Water Filter
Style 1
A
A. Water lter cover door
1. Locate the water filter cover door in the base grille, and pull open
the filter door. The filter will be released and then be ejected as the
door is opened.
2. When the door is completely open, pull the filter straight out.
NOTE: There may be some water in the filter. Some spilling may
occur. Use a towel to wipe up any spills.
3. Take the new filter out of its packaging and remove the covers
from the O-rings. Be sure the O-rings are still in place after the
covers are removed.
4. With the arrow pointing to the left (toward the filter cover door’s
hinge), align the new filter with the filter housing and slide it into
place. The filter cover door will automatically begin to close as the
new filter is inserted.
5. Close the filter cover door completely in order to snap the filter
into place. You may need to press hard.
6. Flush the water system. See the “Water and Ice Dispensers”
section.
Changing the Water Filter
Style 2
1. Locate the water filter cover door in the base grille, and pull open
the filter door.
A
A
A. Water lter cover door
2. Twist the water filter and turn 90 counterclockwise to unlock.
3. Pull the filter out of the housing.
4. Remove the water filter cap from the water filter.
5. Install the water filter cap onto the new filter. Be sure to align the
arrows so the grooves in the filter align with the ribs in filter cap.
Loading ...
Loading ...
Loading ...