Loading ...
Loading ...
Loading ...
3. After 20 seconds, the display will
read CHANNEL X TRANING to
indicate training has started.
Continue to hold the button.
Note: If the channel being trained
has not been previously trained, the
channel will immediately enter the
training mode (no 20 second delay).
4. Point the original garage door
opener/transmitter at the overhead
console. Hold down the original transmitter’s button so the overhead
console can learn the transmitter’s frequency and data stream.
5. Training will be complete in 100
seconds or less. CHANNEL X
TRAINED will be displayed when
training is complete.
6. DID NOT TRAIN will be displayed
if the channel did not properly train.
7. Release the channel X button.
Training is complete.
Note: Additional training may be
required for rolling code equipped
devices. Refer to the Rolling code
programming in this section.
Rolling code programming
To train a garage door opener (or other rolling code equipped devices)
with the rolling code feature, follow these instructions after completing
the “Train mode” in this section. (A second person may make the
following training procedures quicker & easier)
1. Locate the “learn” or “smart” button on the garage door motor
head unit. Exact location and color of the button may vary by product
MODE
RE
SET
CHANNEL X TRAINING
MODE
RE
SET
CHANNEL X TRAINED
MODE
RE
SET
DID NOT TRAIN
Driver Controls
60
Loading ...
Loading ...
Loading ...