Loading ...
Loading ...
Loading ...
4. Press the RESET button to
de-calibrate the compass. The
display will read CIRCLE SLOWLY
TO CALIBRATE for a few seconds
and then display a direction with
CAL displayed on the right side.
5. Slowly drive the vehicle in a
circle (less than 5 km/h [3 mph]). This will take up to three circles to
complete calibration.
6. The correct compass heading will be displayed when the compass is
calibrated.
Note: If the RESET button is not pressed, the compass will exit
calibration mode after three minutes of no activity and the original
calibration data will be restored.
Note: If power is interrupted during the calibration process, the compass
resets to the original calibration data from before the calibration process
started.
HomeLink
T
mode
Train mode
Note: Do not train the HomeLinkt with the vehicle parked in the garage.
To train a HomeLinkt button to control a specific device:
1. Select the HomeLinkt button to
train.
2. Press and continuously hold the
button for 20 seconds. CHANNEL X
TRANSMIT will be displayed (X will
be 1, 2, or 3) during this time.
Note: If more than one button is
pressed, priority will be given to the
lowest numbered channel.
MODE
RE
SET
CIRCLE SLOWLY
TO CALIBRATE
MODE
RE
SET
CHANNEL X TRANSMIT
Driver Controls
59
Loading ...
Loading ...
Loading ...