Loading ...
Loading ...
Loading ...
43
Before You Call
Soil not completely removed after
self clean.
Self Clean was interrupted. Review “Clean” on page 32.
Excessive spills on oven bottom. Clean before starting self clean.
Failure to clean soil from the oven frame, the door liner outside the oven door gasket, and
the small area at the front center of the oven bottom. These areas are not in the self-
cleaning area, but they get hot enough to burn on residue. Clean these areas before
starting the self-cleaning cycle. Burned-on residue can be cleaned with a stiff nylon brush
and water or a nylon scrubber. Be careful not to damage the oven gasket.
Appliance is not level. Poor installation. Place oven rack in center of oven. Place a level on the oven rack.
Be sure floor is level, strong, and stable enough to adequately support range.
If floor is sagging or sloping, contact a carpenter to correct the situation.
Kitchen cabinet alignment may make oven appear not level. Be sure cabinets are square
and have sufficient room for appliance clearance. Cabinets not square or are built in too
tightly. Contact builder or installer to make appliance accessible.
Fan noise occurring after the oven is
turned off.
Some models are equipped with a cooling fan that runs during the cooking process to
cool internal electronic components. It is normal for this fan to continue to run for an
extended period of time, even when the oven is off.
“d-O” is displayed The door was left open and control set for self-cleaning cycle. Close the door and press
STOP.
Cannot move appliance easily.
Appliance must be accessible for
service.
Cabinets not square or are built in too tightly. Contact builder or installer to make
appliance accessible.
Carpet interferes with appliance. Provide sufficient space so appliance can be lifted over
carpet.
Accela-Heat performs poorly Accela-Heat not used correctly. This cooking function is intended for convenience, pre-
cooked, and other specific foods. See “Accela-Heat” on page 20 and follow best prac-
tices.
Loading ...
Loading ...