Loading ...
Loading ...
Loading ...
13
Setting Surface Controls
Important notes:
• For efficient cooking, turn off the element several minutes
before cooking is complete. This will allow residual heat to
complete the cooking process.
• The surface control knobs do not have to be set exactly on
a particular spot. Use the graphics provided as a guide and
adjust the control knob as needed. Each surface element
provides a constant amount of heat at each setting. Refer to
Table 1 for suggested power level settings.
• Start most cooking operations on a higher setting and then
turn to a lower setting to finish cooking.
• Radiant elements have a limiter that allows the radiant
heating element to cycle on and off, even at the HI setting.
This helps prevent damage to the ceramic smoothtop.
Cycling at the HI setting is normal and will occur more often
if the cookware is too small for the radiant element or if the
cookware bottom is not flat.
• A glowing red surface heating area extending beyond the
bottom edge of the cookware indicates the cookware is too
small for the surface heating area.
Turbo Boil Flex Element
Your range is equipped with a 9-inch TURBO BOIL FLEX radiant
element, located at the left front position. This higher wattage
radiant element is best used when bringing larger quantities of
liquid to temperature and when preparing larger quantities of
food.
To operate the Turbo Boil Flex element:
Radiant surface elements may appear to have
cooled after they have been turned off. The glass surface may
still be hot and burns may occur if the glass surface is touched
before it has cooled sufficiently.
Do not place plastic items such as salt and
pepper shakers, spoon holders or plastic wrappings on top of
the range when it is in use. These items could melt or ignite.
Potholders, towels or wooden spoons could catch fire if placed
too close to the surface elements.
Do not allow aluminum foil, empty glass/
porcelain cookware or any material that can melt to make
contact with the ceramic cooktop. If these items melt on the
cooktop they may damage the ceramic cooktop.
1. Place correctly sized cookware on Turbo Boil Flex radiant
surface element.
2. Push in and turn the Turbo Boil Flex surface element control
knob in either direction to the desired setting (Figure 13).
Turn the knob to adjust the setting if desired, ranging from
WARM & SIMMER to MED to TURBO BOIL.
3. When cooking is complete, turn the radiant surface element
OFF before removing the cookware.
Figure 13: Turbo Boil Flex surface element control knob
Figure 14: The Turbo Boil Flex elements
Loading ...
Loading ...
Loading ...