Loading ...
Loading ...
Loading ...
Programme default settings en
23
You can select "Rinse Stop" to prevent
creasing if the laundry will not be taken
out of the washing machine immediately
after the program has ended.
To continue/end the program
~ Page 29
The maximum speed that can be set
depends on the model and program
that has been selected.
Finished in-time
(ñ, ñ Finish in, ñ Ready in)
Before starting the program, you can
preselect the program end ("Ready in"
time) in hourly increments (h = hour) up
to a maximum of 24 hours.
To do this:
1. Select a program.
The program duration is displayed
for the selected program, e.g. 2:30
(hours:minutes).
2. Press the Finished in-time button
repeatedly until the required number
of hours is displayed.
3. Press the A button.
The door will be locked.
The selected number of hours (e.g. 8
h) is shown in the display panel and
counts down until the wash program
starts. The duration of the program is
then displayed.
During the timer count-down, you can
change the preselected number of
hours as follows:
1. Press the A button.
2. Use the Finished in-time button to
change the number of hours.
3. Press the A button.
During the timer count-down, you can
add or remove laundry as required:
1. Press the A button.
2. Open the door and add or remove
laundry.
3. Close the door.
4. Press the A button.
Note: The length of the program is
automatically adjusted when the
program is running.
Certain factors can affect the program
length, e.g.:
■ Program settings,
■ Detergent dosage (additional rinse
cycles if required due to foaming),
■ Load size/type of textiles (longer
washing for higher load and for
textiles which absorb more water),
■ Imbalances (e. g. due to fitted
sheets) are offset with several start-
ups of spin cycles,
■ Fluctuations in power supply,
■ Water pressure (infeeding speed).
Loading ...
Loading ...
Loading ...