Loading ...
Loading ...
Loading ...
1.
Repare
the Chassis.
(MK
models
only–NJ models are
shipped only with chassis and front
grille.)
1.
Remove chassis from cabinet.
2. Loosen the locking screw (A),
then turn the chassis locking plate
90° downward as shown.
Chassis
Locking Plate
MK
Models
3. Loosen the ground screw (B),
then remove the ground wire. Save
the ground wire for reinstallation
later.
1
I
-’”?~
Cabinet
o
B
Ground Screw
2. Mount the Rear Grille.
1.
While holding the grille at
a45°
angle, insert it into clips at the top of
4. Install the Sill
Supper@.
Type B
Type A
Screws (2)
Screws
(4)
th~case and push it toward the unit.
Keep slight upward pressure on the
grille until it fits flush with the
bottom of the cabinet.
Clip
Clip
,,,
..,,,..
. . . . . . .
.......-.-~:.
. . . . .
.
.
.-”
. . . . .
.
..-. -.’’’’-’’”
. . . . .
.
.
~
‘-’’’”
.
.
,.
..
. . . . . .
. . . . . . . . .
.
. . . . .
.
.
m
\
%-3
,,
. .
.
. . . . .
. . . . . . .
~~~~~
‘
1
..
0.
Type E Screws
2. Secure the bottom of the grille
with 2 long grille screws provided
with the grille.
Type
-
F Screws
Note: The rear grille may be
installed from the room side with 2
short screws provided with the grille.
3.
Eepare
the Window.
1.
Measure and mark
thecenterof
the window sill to establish the
mounting position of your unit.
2. Mark the stool 12~’’totheleft
and right of the center of the window
opening. These are the centerlines
4. Pull the bottom corners of the
for the sill
SUDDOrtS.
chassis and slide it out from the
.,
cabinet.
3. Mark the stool 13~’’totieleft
and right of the center of the window
opening. These are the panel index
marks.
e
w@
‘Spacer (2)
1. Assemble sill
-
supports. Do not
+
-Lock
Nut (2)
tighten spacer
—Adjusting
mounting screws
at this time.
$
Bolt
(2)
,
e
Washer (2)
2. Place sill support assemblies on
window stool and select spacer
position that will place the spacer
near the outermost point on the sill.
Tighten screws.
or
mna)
3.
Install sill support assemblies by
locating “V” notch in sill support,
and aligning with sill support mark
on stool. Secure with 2 type F
screws (on each sill support) to rear
of stool. Then install 1
~pe
B
screw through one of the two sill
support holes and into the sill.
4. Adjust sill supports to be level or
1/8” pitch toward the outside by
adjusting bolt and tightening lock
nut. If the sill is wood, the large
washers, provided, should be used
between the bolt head and the sill.
R%MSIDE
stool
/
Ill
i
11
(continued
natpage)
Loading ...
Loading ...
Loading ...