Loading ...
Loading ...
Loading ...
PREPARATION
Preparing for Vacation Preparing to Move
14
For extended vacations or absences, shut off the power to the
refrigerator, move the control to the
“”
position, and clean the
interior with a baking soda solution of 15 ml of baking soda to 1 liter
of water. Wipe dry. To prevent odors, leave an open box of baking
soda in the refrigerator. Leave doors open.
Move icemaker feeler arm to (up) position, which stops
icemaking, and be sure to shut off water supply to the refrigerator.
For shorter vacations, remove perishable foods and leave controls at
regular settings. However, if room temperature is expected to drop
below 16°C, follow the same instructions as for extended vacations.
Disconnect power cord from wall outlet, remove all food, and clean
and dry the interior.
Secure all loose items such as grille, shelves and storage pans by
taping them securely in place to prevent damage.
Be sure refrigerator stays in upright position during actual moving and
in van. Refrigerator must be secured in van to prevent movement.
Protect outside of refrigerator with blanket.
Refrigerator Location Water Supply to Icemaker
Install it on a floor strong enough to support a fully loaded
refrigerator.
Clearances
Allow the following clearances for ease of installation, proper air
circulation, plumbing and electrical connections.
24 Model 28 Model 30 Model
Sides 3 mm 3 mm 3 mm
Top 25 mm 3 mm 3 mm
Back 13 mm 13 mm 13 mm
[If built-in, allow 22 mm for hinge covers.]
If the refrigerator is against a wall on either side, allow 19 mm for
freezer door clearance and 19 mm for fresh food door clearance.
If your refrigerator has an icemaker, or if you plan to add an icemaker
later, the icemaker will have to be connected to a cold drinking
(potable) water line.
A water supply kit containing copper tubing, shutoff valve, fittings
and instructions is available at extra cost from your dealer. There
should be sufficient tubing from the cold water supply to the
icemaker inlet to allow moving the refrigerator out from the wall
several feet (approximately 2.5 m of 1/4″ copper tubing in three
25 cm diameter coils).
Do not use kits with plastic tubing since there is water pressure in the
supply line at all times.
Maximum permissible inlet water pressure—8.3 bars.
Minimum permissible inlet water pressure—1.4 bars.
Installation of icemaker must be made by a qualified service technician.
Dimensions
24 Model 28 Model 30 Model
A* 1746 mm A* 1746 mm A* 1746 mm
B 908 mm B 908 mm B 908 mm
C 719 mm C 833 mm C✝ 876 mm
D 1153 mm D 1251 mm D 1251 mm
* Height does not include hinge.
✝ Add 14 mm for water hook-up.
A
B
C
D
Loading ...
Loading ...
Loading ...