Loading ...
Loading ...
Loading ...
User Manual 12
Getting Started: Installation Cont.
• Attach the curved end of the hose to the corresponding inlet
valve of the washing machine.
• Tighten the coupling nuts securely by hand, as illustrated on
the right and below (Fig. 6 and Fig. 7).
• Tighten the nut by turning it clockwise while holding the hose. (To detach the water supply hose, turn the
nut anticlockwise after turning the tap off.)
• Turn on the taps and check for leaks. Tighten the coupling nuts rmly if there is any leakage. If your water
pressure is strong, close the water tap completely, then open it slightly.
• Make sure your hot water from the tap is no hotter than 60°C.
IMPORTANT!
Both the hot water and cold water hoses must be connected to your taps.
CAUTION!
When tightening the clamping nut, take care not to damage the water inlet valve joint. Apply force evenly and
do not twist the water inlet valve.
CAUTION!
Use only the new (supplied) hoses with your new appliance. Do not use a hose from an existing machine, or
one that has been used previously.
CAUTION! In the event that the hoses are too short for your set-up, please seek advice from your local
washing machine store to purchase a longer hose.
Fig. 6
Fig. 7
Loading ...
Loading ...
Loading ...