Loading ...
Loading ...
Loading ...
228
❑
With the engine OFF and cool, remove the
pressure cap, located on the coolant reservoir.
Remove the heater hose and clamp, located on
the rear of the intake manifold.
❑
Add a 50/50 mixture of specified coolant and
water to the coolant reservoir. Refer to Refill
Capacities later in this chapter for the correct
amount. Add coolant to the reservoir until the
coolant continuously flows out of the tube in
the rear of engine. Reattach hose and secure
clamp.
❑
Reinstall the pressure cap to the fully installed
position.
❑
Start and idle the engine until the radiator
upper hose is warm (this indicates the
thermostat is open and coolant is flowing
through the entire system).
❑
Immediately shut off the engine and let cool.
Cautiously remove the pressure relief cap and
add a 50/50 mixture of specified coolant and
water until the coolant is at the COLD FILL
level in the coolant reservoir.
❑
Reinstall the pressure cap securely.
❑
Check for leaks at the draincock.
❑
Recheck the engine coolant level, using the
recommended procedure, after one or two
occasions of vehicle use.
File:11fnmct.ex
Update:Mon Jun 17 13:54:56 1996
Loading ...
Loading ...
Loading ...