Loading ...
Loading ...
Loading ...
20
LIGHTS DISPLAYED POSSIBLE CAUSE REMEDY
FLASHING
FLASHING
The grinding is too ne and the coee is
delivered too slowly or not at all
Repeat coee delivery and turn the grinding
adjustment dial (A5 -
g. 8
) one click clockwise
towards "7" while the coee grinder is in oper-
ation. If after making at least 2 coees delivery
is still too slow, repeat the correction procedure,
turning the grinding adjustment dial another
click until delivery is correct (see section “13.1
Adjusting the coee grinder”).
If the problem
persists, make sure the water tank
(A17) is fully
inserted, turn the steam/hot water dial (A22) to
the
I position and deliver a little water until the
ow is regular.
If the water softener lter (C4) is present,
an air bubble may have been released in-
side the circuit, obstructing delivery
Deliver a little water by turning the steam/hot
water dial (A22) to the I position until the ow
is regular.
FLASHING
FLASHING
The pre-ground coee used is too ne
and the coee is delivered too slowly or
not at all
Repeat coee delivery using less pre-ground
coee, or a dierent type.
If the problem persists,
make sure the water tank
(A17) is fully inserted,
turn the steam/hot water dial (A22) to the
I
position and deliver a little water until the ow
is regular.
If the water softener lter (C4) is present,
an air bubble may have been released in-
side the circuit, obstructing delivery
Deliver a little water by turning the steam/hot
water dial (A22) to the I position until the ow
is regular.
FLASHING
+ OK
ON STEADILY
A LONG coee with pre-ground coee
has been requested
Put one level measure (C2) of pre-ground cof-
fee into the pre-ground coee funnel (A4) and
press
OK (B15) to continue and complete
preparation.
ON STEADILY
FLASHING
Too much coee has been used
Select a lighter taste by pressing
(B8) or
reduce the quantity of pre-ground coee.
The TrueBrew Over Ice ™ Coee but-
ton have been pressed without selection
the strength
Select the strength and then press thethe
TrueBrew Over Ice™ button.
Loading ...
Loading ...