Loading ...
Loading ...
Loading ...
Trouble shooting en
27
5. Press the front panel at the bottom until it clicks
audibly into place (figure %).
6. Open the appliance door again slightly and remove
the tea towel.
7. Screw both screws back in on the left and right.
8. Put the cover back in place and press on it until it
clicks audibly into place (figure &).
9. Close the appliance door.
Caution!
Do not use the cooking compartment again until the
panels have been correctly fitted.
3Trouble shooting
Tr oubl e s hoot i ng
If a fault occurs, there is often a simple explanation.
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.
Rectifying faults yourself
You can often easily rectify technical faults with the
appliance yourself.
If a dish does not turn out exactly as you wanted, you
can find useful cooking tips and instructions at the end
of this instruction manual. ~ "Tested for you in our
cooking studio" on page 32
--------
Fault Possible
cause
Notes/remedy
The appliance is
not working.
Defective cir-
cuit breaker.
Check the circuit breaker in the
fuse box.
Power failure Check whether the kitchen light
or other kitchen appliances are
working.
The time is flash-
ing on the display.
Power failure. Reset the time.
The settings on
the appliance
cannot be config-
ured. A key sym-
bol has lit up on
the display or
†‘”“.
The child-
proof lock is
activated.
Deactivate the childproof lock by
pressing and holding the button
with the key symbol for approx. 4
seconds.
The appliance
door will not
open. A key sym-
bol has lit up on
the display.
The appliance
door is locked
with the child-
proof lock.
Deactivate the childproof lock by
pressing and holding the button
with the key symbol for approx. 4
seconds.
The lock can be switched off in
the basic settings.
The appliance
door will not
open. A lock
symbol H has lit
up on the display.
The appliance
door is locked
by the clean-
ing function.
Wait until the cooking compart-
ment has cooled down and the
lock symbol H has gone out.
After an operating
mode is switched
on, œ is flashing
on the display.
The appliance
has not
cooled down
sufficiently.
Switch off the appliance, allow it
to cool down and switch on the
operating mode again.
The appliance is
not heating. The
colon is flashing
on the display. On
some appliances,
a š will also
appear on the dis-
play.
Demo mode
is activated.
Briefly disconnect the appliance
from the mains (switch off the cir-
cuit breaker in the fuse box) and
then deactivate demo mode
within approx. 5 minutes by
changing the basic setting ™‚„
or ™› to ‹. ~ "Basic settings"
on page 20
Loading ...
Loading ...
Loading ...