Loading ...
Loading ...
Loading ...
EN -18-
FAULT POSSIBLE CAUSE TROUBLESHOOTING
Excessive foam is formed in the
detergent drawer.
Excessive amount of detergent
used.
Press on Start/Pause button To
eliminate foam formation, mix a
spoon of softener with half litres
of water, and pour the mixture in
the detergent drawer. After 5-10
minutes, press on Start/Pause
button again. In your next washing
operation, Adjust the detergent
dose accordingly.
Wrong detergent used.
Use detergents produced only for
automatic washing machines in
your machine.
Unsatisfactory washing result.
The contamination degree of your
laundries does not match the
programme you have chosen.
Select the programme appropriate
for the contamination degree of
your laundries. (See programme
table)
Amount of detergent used
insufcient.
Adjust the amount of detergent
based on the amount and
contamination degree of your
laundries.
Laundries in excess of maximum
capacity put in your machine.
Load your machine with laundries,
amount of which will not exceed
maximum laundry capacity.
Water being hard.
( Contaminated, lime water etc.)
Adjust the amount of detergent
based on the instruction of
detergent manufacturer.
Laundries distributed in your
machine non-homogenously.
Spread your laundries in
the machine properly and
homogeneously.
As soon as the machine is loaded
with water, water discharges.
The end of water discharging hose
is too low for the machine.
Set the water discharging hose on
appropriate height. (**)
No water appears in the drum
during washing.
No fault. Water is in the unseen
part of the drum.
-
Laundries have detergent
residues on them.
Non-dissolving particles of some
detergents may stick to your
laundries as white spots.
Perform an extra rinsing by
setting your machine to “Rinsing”
programme, or clean the spots
using a brush after your laundries
dry.
Grey spots appear on the
laundries.
The reason for such spots may be
oil, cream or ointment.
Apply the maximum amount
of detergent instructed by the
detergent manufacturer in the next
washing operation.
Spinning operation is not
performed or runs late.
No fault. Unbalanced load control
system has been activated.
Unbalanced load control system
will try to spread your laundries
homogeneously. Wringling
operation will begin after your
laundry is spread. Place the
laundry in the machine in a
balanced fashion the next time.
(**) See the chapter regarding installation of your machine.
CHAPTER -10: TROUBLESHOOTING
Loading ...
Loading ...
Loading ...