DIP SWITCH SETTINGS
w
口
棚跚
－
。
国国】
4
Hold Time
Stand-by Time
OFF
｜｜二｜
50fc
｜｜二｜
50%
。
10min 15min
。N
30fc
100%
．
5min
3in
Default
����
国
：
O
switch down
Sensor 。N
hold time 5min,stand-by time 3min
30fc
100%
Poson#1
Sensor Status
D
escption
Sensor oti咱，de惚cmoobject light s阳yon, no movi咱obj I地ht
ll go into st日ndbymode，r a p回国me ofs恒ndbymode, light will o.
Deaivated sensor funion, light will阳ep on.
ON
Sensor ON
。FF Sensor OFF
Pition #2 Brightness Level D眉cription
。
N
Higher brightness
rding to the natural light, the xture ll回时ier tum into full p口wer.
(aund 5c)
。FF
Stand a brightness
rding to the natural light, the ftu II later tum into ll per.
(around 3c)
P帽恼。n#3
Detection阁nsitive
Description
Widaund 34
e er distan that臼n be de怡cted
。N
diameter detection
range
Staard-aund 17 S也nda distan that can be detected
OFF
diameter detection
range
-3-
P铺ition桐
Time Level
Description
5mins hold time+
No moving object de协cted, light will s阳y「 5mins, aer 5mins the light
ON
3mins stand-by time
will go in 30% brighess s恒nd-bymode, aer 3mins stand -by me the
light will turn o低Tl 8mins to o仔．
10mins hold time+ No moving object de饱ed, light will s恒y r 10mins, aer 10mins the
OFF
15mins s恒nd-bytim
1
light will go into 30% brightne副and-byme, aer 15minsnd-byme
e light will tum g膏.To恒I 25mins to o青．
WIRING DIAGRAMS
L
N
Dimm可
口
＋
＋
HY2.0-3P
V1.0
-4-
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
1)This device may not cause interference.
2)This device must accept any interference, including interference that may cause undesired operation of the
device.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
FCC Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This
transmitter must not be co-located or operating in conjunction with any other antenna or transmitter .
1.This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your
body at all times.
2.This device has been evaluated to meet general RF exposure requirements and can be used in mobile exposure
conditions without restriction.
