
Push down for 1st gear / Push up for 2nd
User Manual
Model: X-07
Heater speaker
gear / Middle position for shutdown
Long press power onvoff/ double click to
switch Bluetooth mode
White noise
Previous track /long press volume down
Next track / Long press to add music
X-07
196*159*105mm
110
5.3
110
400W
220V~
ABS/PC/Silicone/PA66
Bluetooth
45mm
24 hours
up amd dowm 1 10
FCC Caution:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used
in portable exposure condition without restriction.
·Please read the "Safety Precautions" carefully before use and follow them correctly to avoid damage
or danger due toimproper use. After understanding this section's content, please read the main body
of the user manual and keep it properlyfor all users to refer to at any time.
·This productis Class lequipment with a working power supply of 20v~50Hz. Befare use, please ensure
that the power supply matcthes the supplied power source,
·Do not use flexible wires for moving sockets or share one socket with other appliances. This device
cannot operate underexternal timers or independent remote control systems; all repairs must be
carried out by professional technicians.
·the power cord is damaged, to avoid danger, it must be replaced by professionals from the
manufacturer's repair department or similar departments
·If there is damage to the main body or other pats ofthe product, do not use it and send it to the
designated repair service point fornspection and repair, Do not disassemble or modify it yourself
unless you are a professional or authorized repair person.
·Duringuse,do not move the product.lfproblemsoccur,unplugthe power cord from the socket rst;do
not plug or unplugthe power cord withwet hands to avoid electric shock
·Do not pull, press, or let them hang along sharp objects or edges; keep away from heat sources and
moisture.
·Do not insert metal or other foreign objets into the ventila tion holes or gaps, as this may cause
damage or electric shock hazards
·Do not place flammable or explosive items around the electric heater and do not use it in places
with severe dust.
·Do not place this product on surfaces near heat sources such as cookers or ovens; when not in use
for an extended period,store the produc in a dry place.
·Do not place this product on unstable or tilted surfaces to avoid accidents such as falls causing
injuries or fires
·Do not immerse power cords, plugs, or entire units in water or other liquids to avoid damaging
this product and causing electric shock.
·Do not let water get on the product to avoid short circuits and electric shocks
·Do not block or cover the outlet and inlet when using the product; otherwise, there may be safety
hazards.
·Do not place or wrap power cords near the outlet position; when using them, do not let the outlet
blow on the power cordas this can cause the power cord to remain at high temperatures for an
extended period and pose safety hazards.。
·Do not place the heater under the power outiet when using the product to prevent hot air from
rising and accelerating the aging of the rubber shell
·Do not allow any liquid to enter the electrical appliance to prevent leakage and electric shock hazards
·During use of the electric he ater, do not touch high-temperature parts (such as protective covers).
·Do not use electric heaters in damp places such as bathrooms, shower rooms, and swimming pools
Usage Guide
Common Problem Analysis Table
Fault Phenomenon
Possible Causes
Handling Method
Electricheater does not
heat or blow air
The plugwxn
Tpluggedprcpe ry
Knob switch not turned on
Plug the plug
Tumn on the switch
Aneleciicheperonlyblowste
aranddoesnotheat
An electric heater only
heats, not blows
PTC malfunctionc
Fan failure
Please contact the dealer
Electric heater suddenly
stops working
Power plug loose
Plug the plug
Electric heater suddenly
stops working
Air inlet or outlet is blocked
Remove blockage
Please contact the dealer
Note: lf after analyzing the above symptoms and still unable to rule out the
fault, please contact our company's repailpoint or dealer. lt is strictly
prohibited for non-professionals to disassemble this machine on their own.
Cleaning and maintenance
·Before cleaning, please make sure to turn off the machine, unplug the plug, and wait for the
electric heater to cool completely before cleaning.
·When cleaning, you can use a soft cloth dampened with a small amount of water or neutral
cleaner for gentle wiping.
·Do not rinse the electric heater directly with water to avoid water eritering the machine and
causing malfunctione
. When not used for a long time,clean the electritc heater thoroughly.After drying, return it to its
original packaging box and store itin a dry place.
Warm Reminder:
1.Do not cover things with high temperatures.
2. Keep at least 09 meter between wires, flammable materals,flammable fabrcs, and other
fumniture from the frontand back of the electric heater's outle
3.When the product is working, do not touch the grille.
Functions
Specifications
Model
Rotation Angle
Power
Speaker
Playback Duration
Bluetooth Version
Bluetooth Reception Distance
Input
Texture oftimber
Playback Mode
Product Dimensions
110-degree rotation
Can rotate up and down by 110 degrees
to adjust the appropriate angle
·Warning:To avoid overheating, do not cover the electric heater.
·This electric heater is not suitable for people with disabilities, children, mentally ill patients, or
inexperienced individuals using oiplaying with this product, To ensure safety, use only under the
quidance of someone familar with how to operate this product
·Do not insert any objects into any gaps or openings.
·This machine cannot be usedin greenhouses.
·This product is only suitable for household or simlar purposes and should not be used for
commercial or other purposes.
Electricheater does not
heat or blow air
暖风机

