FCC ID:XO8-HALO319V2 rev: 001
Instant Care Halo Transmitter
Model #: HALO319-SL+
• Identifying the Parts
1
1. Emergency Button/ LED
Learning-in the Halo Transmitter
Please refer to your base station’s user guide for instructions on learning-in your Halo transmitter.
Operation
To dial Emergency Line:
Press once on the Emergency button, the Blue LED will illuminate for .5 seconds and transmit
the message to the Control Panel.
Sleep Mode:
-The Halo Transmitter ships in “Sleep Mode” to conserve battery life
-To exit sleep mode, press and release the emergency button
➢ LEDs:
-Blue LED = good pendant battery
-Red LED = low pendant battery
Battery & Electrical Specifications
Frequency: 319.5MHz
Battery: CR2032, 3V 230mAh
Battery life: 2yrs with an average of one button push per day.
Open Field Range: Approximately 200 ft.
Low battery status: when the battery voltage is below the threshold, the Halo Transmitter will indicate a
low battery by illuminating the RED LED for .5 seconds when the Emergency button is pressed. A low
battery notification will be sent to the base station with the button press. Low battery supervisory will
occur once every 15 hours thereafter.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any interference received, including interference that may cause
undesired operation.
FCC Caution
To assure continued compliance, any changes or notifications not expressly approved by the party responsible for compliance may
void the user’s authority to operate his equipment. (Example – use only shielded interface cables when connecting to computer or
peripheral devices)
FCC Section 15.105 Information to the user.
NOTE:
This equipment has been tested and found to comply with the limits for a lass B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC ID:XO8-HALO319V2 rev: 001
- IC Statement:
This Class [B] digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du Canada.
Statement :
This device complies with RSS-247 and ICES-003 of the Industry Canada Rules. Operation is subject to the following
two conditions : (1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation of this device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
IMPORTANT NOTE:
IC Radiation Exposure Statement:
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 5mm between the radiator & your body.
NOTE IMPORTANTE:
Déclaration d'exposition aux rayonnements d'IC :
- Cet équipement est conforme aux limites d'exposition aux rayonnements IC RSS-102 définies pour un
environnement non contrôlé. Cet équipement doit être installé et utilisé avec une distance minimale de
5mm entre le radiateur et votre corps.
