1. NC Indicator
2. Power Indicator
3. To USB Power Charge Battery
4. Microphone
5. Line in
6. Previous / Volume -
7. Next / Volume +
8. Power Switch/Phone/Play
9. Noise Cancelling On / Off Button
Press "NC" and switch among
tranparency/noise cancelling low/noise
cancelling high/noise cancelling off
1. Power on the headphone
2. Press ANC button to switch between tranparency/ noise cancelling low/noise cancelling
high/noise cancelling off.
RESET
When power on and without pairing, hold "+" and "-" buttons 5
seconds to restore the setting, and turn off the device
CRI-600
CRI-600 CRI-600
CRI-600
CRI-600
Centerpointe Headphone
CRI-600
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
FCC&ISED Radiation Exposure statement
The device has been evaluatec to meel general RF exposure requirement. The device can be used
in portable exposure condition without restriction.
Déclaration d’exposition aux rayonnements FCC&ISED
Le dispositif a été évalué en fonction des exigences générales d’exposition aux RF. L’appareil
peut être utilisé en condition d’exposition portable sans restriction.
- The device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the
following two conditions:
- (1) This device may not cause interference.
- (2) This device must accept any interference, including interference that may cause undesired
operation of the device.
- L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux
CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils
radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
- 1. L’appareil ne doit pas produire de brouillage;
- 2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
