Loading ...
Loading ...
Loading ...
1773/1775/1777
Users Manual
24
Auto-Copy Data to USB
The Analyzer supports automatic actions on insertion of the USB flash drive. This is helpful to
gather data from the Analyzer without the need to establish a connection to the Analyzer to
download the data to the PC.
To enable the auto-copy mode:
1. On a USB flash drive, create the folder Fluke177x (no spaces in file name).
2. Create a file AutoCopyData.txt in the \Fluke177x folder.
3. Make sure the Analyzer is powered from mains.
4. Plug the USB flash drive into the Logger.
All recorded measurement data is copied to the USB flash drive. During the file transfer the
Start/Stop LED flashes white. This can take a few minutes depending on the amount of stored
data. You can remove the USB flash drive when the Start/Stop LED changes color to green. If
the LED is amber, an important warning or information is available. See the remote control
software, such as Energy Analyze Plus, for more information.
To disable the auto-copy mode:
1. Go to the folder Fluke177x on the USB flash drive.
2. Remove or change the name of the AutoCopyData.txt file.
First-time Use/Setup Wizard
Before you start:
1. Attach the wire clips to both sides of the current probe cables. Depending on the region,
use clips labeled A, B, C, N or 1, 2, 3, N.
2. Assemble the magnet hanger if you plan to use.
3. Connect the Analyzer to mains power and follow the first-time use/setup wizard to
configure the date, time, time zone, phase color scheme and label, as well as nominal
voltage and frequency.
4. Keep the Analyzer turned on until the battery is fully charged.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...