Loading ...
Loading ...
Loading ...
Rinnai 25 HW_CF OIM
GAS PRESSURE SETTING
The regulator is electronically controlled and factory pre-set� Under normal circumstances it DOES NOT require
adjustment during installation� Make adjustments ONLY if the unit is not operating correctly and all other possible
causes for incorrect operation have been eliminated� Instructions for gas pressure setting are located in the
instruction pocket inside the appliance front cover�
NOTE
For all injector size and gas pressure values refer to the appliance data plate, located on the left
hand side of the water heater�
WIRING DIAGRAM
The wiring diagram is located in the instruction pocket inside the appliance front cover�
COMMISSIONING CHECK LIST
A commissioning check list is provided on the appliance front cover to enable the installer to step through the
correct commissioning procedure when installing a Rinnai Continuous Flow water heater�
The check list can also assist the installer to identify potential installation errors that may prevent the appliance
from operating correctly�
INSTALLATION RECORD
The Installation Record is a reference for the end user, help line staff and service technicians� Ensuring that this
information is available here will be helpful in the event that a service enquiry is required.
Installer Details
Installation Company Name:
Address:
Telephone / Mobile Phone: /
Email:
Certicate of Compliance / Certication No.:
Authorised Persons - Licence No�:
Installers Name:
Installers Signature:
Installation Date:
System Details
Water Heater - Model Number *: REU-
Water Heater - Serial Number *:
* This information will need to be copied from the data plate, located on the left hand side of appliance.
Installation Address:
COMMISSIONING
Loading ...
Loading ...
Loading ...