Loading ...
Loading ...
Loading ...
Stay fully and in the center of the seat to make sure
that the engine operates correctly and does not stop on
rough terrain or hills.
1. Set the correct cutting height. Refer to
To set the
cutting height on page 14
.
2. Move the attachment clutch control.
a) Pull the attachment clutch control upwards to
engage the cutting deck.
b) Push the attachment clutch control down to
disengage the cutting deck.
To get a good cutting result
• For best performance, do maintenance on the
product regularly as given in the maintenance
schedule. Refer to
Maintenance schedule on page
18
.
• Do not cut a wet lawn. Wet grass can give a bad
cutting result.
• Do not use tire chains when you attach the cutting
deck to the product.
• Make sure that the cutting deck is level. Refer to
To
adjust the parallelism of the cutting deck on page
24
.
• If the grass is high, start with a high cutting height
and decrease it gradually.
• Move the product forward at low speed if the grass is
high and thick.
• Use full throttle when you cut the grass.
• Cut the grass in an irregular pattern.
• Use the left side of the cutting deck when you
cut near trees, bushes or paths. The blade cuts
approximately 15 mm in from the side of the cutting
deck.
• When you cut large areas, move the product to the
right during 1 or 2 turns around the work area. This
procedure will keep the grass discharge away from
shrubs, fences and driveways. After approximately
2 turns around the work area, cut in the opposite
direction.
• To get the best cutting result, cut the grass
frequently.
To put the product in freewheel mode
If it is necessary to move or tow the product without aid
from the engine, you must put the product in freewheel
mode.
WARNING: Do not put the product in
freewheel mode on a slope.
• Push in the freewheel control lever (A) to put the
product in drive mode.
A
• Pull out the freewheel control lever to put the product
in freewheel mode.
Maintenance
Introduction
WARNING: Read and understand the
safety chapter before you do maintenance
on the product.
2235 - 002 - 22.09.2023 17
Loading ...
Loading ...
Loading ...