Loading ...
Loading ...
Loading ...
App: 3R-Installer App
Device: Smart Bridge MZ1
Set up your smart bridge, make sure both the 3R-Installer App and
the smart bridge's firmware are in the latest version.
Push to open the back cover of the sensor and install the batteries.
Press and hold the reset button for 5 seconds to factory reset the
sensor, the LED light will turn red and flash in blue, indicating en-
tering Zigbee pairing mode. It will exit pairing mode after 3 min if
not paired.
Tap the smart bridge icon to enter the devices page, tap "+ Bridge
ZIGBEE Devices" to start Zigbee pairing, follow the on-screen
instructions to add device.
Tab Link With Matter Enabled Services, copy the Manual Setup
Code or Scan the QR Code within 3 min, then you can add the
bridge to other Matter supported ecosystems through multi-admin.
1.
2.
3.
4.
5.
Pairing with 3R-Installer
Pairing steps:
07
Loading ...
Loading ...
Loading ...