Loading ...
Loading ...
Loading ...
Ti9, Ti10, Ti25, TiRx, TiR and TiR1
Users Manual
4
Charging the Battery
Before using the Imager for the first time, charge the battery for at least two
hours. The Imager’s battery condition is displayed in the upper-left corner of
the display. When the last segment of the battery icon extinguishes, the Imager
will shut down and will require recharging before operating again. To charge
the Imager’s battery:
W Caution
To avoid damage to the Imager, remove it from the DC car
charger before starting or jump starting the vehicle.
Note
Ensure the Imager is near room temperature before connecting it to
the charger. See the charging temperature specification. Do not
charge the Imager in hot or cold places. Charging in extreme
temperatures reduces the battery pack’s ability to hold a charge.
1. Plug the ac input of the battery charger into an ac wall outlet.
2. Plug the battery charger’s dc output into the Imagers ac adapter socket.
The optional Car Charger can also be used to recharge the Imager’s battery.
While the battery is charging, the battery icon appears as A while the
Imager is operating. With the Imager off, b appears in the display while
connected to the battery charger.
Keep the Imager attached to the charger until the battery condition icon
indicates a full charge. With the Imager off, the battery charge icon will have
four full bars. With the Imager on, turn the Imager off to view the battery
condition icon. Removing the Imager from the charger before a full charge is
indicated will deprive the battery of a full charge and thus shorten the run time.
Note
New batteries are not fully charged. Two to ten normal
charging/discharging cycles may be required before the battery
charges to its maximum capacity.
Turning the Imager On and Off
To turn the Imager on or off, press the center softkey (a) for two seconds.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...