Loading ...
Loading ...
Loading ...
70
4.5.4 SIP
The Session Initiation Protocol(SIP) is a signaling communications protocol, widely used for
controlling multimedia communication sessions such as voice and video calls over Internet Protocol(IP)
networks. This page allows user to configure SIP related parameters. Milesight cameras can be configured as
SIP endpoint to call out when alarm triggered; or allow permitted number to call in to check the video if the
video IP phone is used. To use this function, the settings in SIP page must be configured properly. There are
two ways to get video through SIP, one is to dial the IP address directly, the other is account registration mode,
the details are as follows:
Method 1: IP Direct mode
Dial on the camera’s IP address directly through SIP phone, so you can see the video.
(Note: SIP phone and the camera should in the same network segment).
Method2: Account registration mode
1) Before using the SIP, you need to register an account for the camera from the SIP server;
2) Register another user account for the SIP device from the same SIP server;
3) Call the camera User ID from the SIP device, you will get the video on the SIP device.
SIP Settings
Figure 4-5-20 SIP Settings
Table 4-5-12 Description of the buttons
Parameters Function Introduction
Unregistered/Registered
SIP registration status. Display “Unregistered” or “Registered”
Enable Start or stop using SIP
Register Mode
Choose to use Enable mode or Disable mode. Enable mode means to use SIP
with register account. Disable mode refers to use SIP without register account,
just use the IP address to call.
User ID SIP ID
User Name SIP account name
Password SIP account password
Server Address Server IP address
Server Port Server port
Connection Protocol UDP/TCP
Video Stream Choose the video stream
Max Call Duration The max call duration when use SIP
Note:
1) SIP supports Directly IP call;
2) SIP only supports second stream with H.265/H.264 or MPEG4 Video Compression.
Loading ...
Loading ...
Loading ...