Loading ...
Loading ...
Loading ...
Chapter 5 To Trigger the Oscilloscope RIGOL
MSO8000 User's Guide 5-57
Trigger Output Connector
The trigger output connector ([TRI G OUT]) on the rear panel of MSO8000 series
can output trigger signals (hardware trigger) determined by the current setting.
Figure 5-24 Trigger Output Connector
Press Utility ïƒ Syst em ïƒ AUX Out to select "TrigOut". A signal which reflects the
current capture rate of the oscilloscope can be output from the [ TRI G OUT]
connector each time a trigger is generated by the oscilloscope. I f this signal is
connected to a waveform display device to measure the frequency, the measurement
result is the same as the current capture rate.
Note: If you press Utility ïƒ System ïƒ AUX Out to select "PassFail", then in the
pass/ fail test, when a pass/ fail event is detected, the oscilloscope outputs a pulse
from the rear-panel [ TRI G OUT] connector.
Trigger Output Connector
Loading ...
Loading ...
Loading ...