Loading ...
Loading ...
Loading ...
![](https://files.manualsfile.com/22283163-ds-k3g200lx/bg3d.png)
Memory Mode
Mulple cards presenng for mulple persons passing is
allowable when enabling the memory mode. When the
passing person's number exceeds the card presenng
number, or aer the latest person passing with no other
person passing within the door open duraon, the door will
closed automacally.
4.
Click OK.
7.7.2 Congure Device Parameters
Aer adding the access control device, you can set its parameters
such as network parameters.
Set RS-485 Parameters
You can set the access control device's RS-485 parameters
including the baud rate, data bit, the stop bit, parity type,
ow
control type, communicaon mode, work mode, and connecon
mode.
Before You Start
Add access control device to the client, and make sure the device
supports RS-485 interface.
Steps
1.
Enter the Access Control module.
2.
On the
navigaon bar on the le, enter Advanced Funcon →
More Parameters .
3.
Select an access control device in the device list and click
RS-485 to enter the RS-485 Sengs page.
4.
Select the serial port number from the drop-down list to set
the RS-485 parameters.
5.
Set the baud rate, data bit, the stop bit, parity type, and
connecon mode in the drop-down list.
6.
Click Save.
•
The
congured parameters will be applied to the device
automacally.
•
When you change the connecon mode, the device will
reboot automacally.
Enable M1 Card Encrypon
M1 card encrypon can improve the security level of
authencaon.
Steps
Note
The funcon should be supported by the access control device
and the card reader.
1.
Enter the Access Control module.
2.
On the
navigaon bar on the le, enter Advanced Funcon →
More Parameters .
3.
Select an access control device in the device list and click M1
Card
Encrypon to enter the M1 Card Encrypon page.
4.
Set the switch to on to enable the M1 card
encrypon
funcon.
5.
Set the sector ID.
49
Loading ...
Loading ...
Loading ...