Loading ...
Loading ...
Loading ...
Installation
English42
Using the short hose as an extension (applicable models only)
B
A
C
1. Close the cold water tap. If you have a washer’s cold
water hose attached to the cold water tap, unscrew
and remove the hose. Then, connect the short hose
(B) to the cold water tap. Turn the coupling by hand
until it is tight.
2. Using pliers, tighten the coupling an additional two-
thirds turn. Do not overtighten. You can damage the
coupling.
3. Connect the Y-connector (A) to the brass male end
of the short hose. Turn the coupling by hand until it
is tight.
4. Using pliers, tighten the coupling an additional two-
thirds turn. Do not overtighten. You can damage the
coupling.
5. Connect the angled end of the water hoses (C) to the
filling valve at the bottom rear of the dryer. Turn the
coupling by hand until it is tight.
6. Using pliers, tighten the coupling an additional two-
thirds turn. Do not overtighten. You can damage the
coupling.
7. If you detached the cold water hose from your
washer, attach the hose to the free end of the
Y-connector, tighten the coupling by hand until it is
tight, and then, using a pliers, tighten an additional
two-thirds turn.
8. Open the cold water tap, and then check for any
leaks.
STEP 11 Power on
Plug the power cord into a wall socket protected by a fuse or circuit breaker. Then, tap
to turn on the
Laundry Hub.
For gas models
Make sure all gas connections, the exhaust line, and all wiring is connected correctly. Then, plug the power
cord into a power source and check the dryer’s installation and operation using the final checklist in Step
12.
Untitled-1 42 2023-12-18() 5:49:29
Loading ...
Loading ...
Loading ...