Loading ...
Loading ...
Loading ...
5.
When the person exits, click to stop calibraon.
Note
Aer auto calibraon, refer to Verify the Calibraon Result to verify if the calibraon is
successful. Set manual calibraon if the auto calibraon failed, or the veried result turns bad.
Result
Aer calibraon, the height and angle of camera will be shown in live view.
Calibrate Manually
Steps
1.
Go to Conguraon → Perimeter Protecon → Camera Calibraon .
2.
Check Manual
Calibraon.
3.
Click Fig 1. Click and drag the vercal line unl it ts the target.
4.
Enter the actual length of the
calibraon line.
5.
Repeat steps above to set Fig 2, Fig 3, and Fig 4.
Note
Draw a calibraon line in each gure, and the four calibraon lines should be evenly distributed
in the same horizontal plane from le to right.
In the four gures, the calibrated object doesn't need to be the same. Select a proper object in
each
gure.
6.
Oponal: Click to delete the calibraon line.
7.
Click Save.
Cauon
●
Separate 4 vercal lines in the opcal-axis direcon at the close site, middle and far site
respecvely.
●
Separate 4 vercal lines at the le, middle and right of the image respecvely.
●
If manual
calibraon's result is incorrect, select another target to recalibrate.
●
Aer manual calibraon, refer to Verify the Calibraon Result to verify if the calibraon is
successful.
Result
Aer calibraon, the height and angle of camera will be shown in live view.
Verify the
Calibraon Result
The funcon can verify whether the calibrated value is consistent with the actual value.
Thermal Network Camera User Manual
55
Loading ...
Loading ...
Loading ...