Loading ...
Loading ...
Loading ...
22
OPERATION
2. Fill the suction hose with water and allow all of the entrapped air to escape.
3. Connect the suction hose to the washer. Remove all attachments.
4. Switch on the washer and press the trigger until the washer discharges a steady stream
of water. If this is not achieved within 2 to 3 minutes, switch the washer off and check
the suction hose for entrapped air.
5. Switch off the washer and connect the desired attachment.
6. Operate the washer as usual. In addition, please refer to the user manual of the relevant
accessory part.
Using the cleaning attachments
Fitting the spray lance (Fig. F)
WARNING!
Risk of injury!
The high-pressure jet is very hard and can inflict injury.
- Start using the washer by working at a substantial distance and reduce this as needed.
The spray lance is equipped with a quick lock to assist in changing the
cleaning attachments.
1. Insert the spray lance into the spray gun in such a way that the end of the quick lock
points away from the spray gun.
2. To fix the spray lance, push it slightly downwards and turn it clockwise at the same time.
Removing the spray lance
1. Stop the washer and move the ON/OFF switch to OFF.
2. Push the trigger until the pressure in the washer has been released.
3. Push the spray lance slightly in the direction of the spray gun and turn the spray lance
anticlockwise at the same time.
4. Remove the spray lance.
Fitting the turbo nozzle (Fig. G)
NOTE!
Risk of damage!
When using the turbo nozzle, there is a very high risk of damaging
sensitive surfaces.
- Be very careful when using the turbo nozzle during cleaning.
- Start using the washer by working at a substantial distance and reduce this as needed.
Loading ...
Loading ...
Loading ...