Loading ...
Loading ...
Loading ...
46
4. Set alarm detection area.
Click “Draw Area” and drag the border lines of the rectangle to modify its size. Move the
rectangle to change its position. Click “Stop Draw” to stop drawing the area. Click “Clear” to
clear the area. Then set the detectable face size by defining the maximum value and the
minimum value (The default size range of a single face image occupies from 3% to 50% of the
entire image).
5. Advanced settings. Choose the snapshot interval and number as needed to avoid
capturing multiple similar pictures in a very short period of time.
Snapshot Interval: If 5 seconds is selected, the camera will capture the same target once
every 5 seconds during its continuous tracking period.
Snapshot Number: If the snapshot number is enabled and set (eg. 3), the camera will
capture the same target once every 5 seconds and it will capture this target 3 times at most
during its continuous tracking period. If the snapshot number is disabled, the camera will
capture the same target once every 5 seconds until the target disappears in the detected
area.
6. Set the schedule of the face detection. The setup steps of the schedule are the same as
schedule recording setup (See 4.1.4.1 Schedule Recording Settings).
※ Configuration requirements of camera and surrounding area
1. Cameras must be installed in the area with stable and adequate light sources.
2. The installation height ranges from 2.0 m to 3.5 m, adjustable according to the
focal-length of different lenses and object distances.
Loading ...
Loading ...
Loading ...