Loading ...
Loading ...
Loading ...
39
4.5.7 Target Counting by Area
This function is to calculate the number of the people or vehicles intruding into the pre-defined
area through detecting, tracking and counting the shapes of the people or vehicles.
1. Go to Config→Event→Target Counting by Area as shown below.
2. Enable target counting by area, select the snapshot type, the detection target, counting
reset and alarm linkages. The setup steps are the same as the target counting by line.
3. Set the statistic area. Click the “Area” tab to go to the interface as shown below.
Select the alarm area number on the right side. Only one alarm area can be added.
Click the “Draw Area” button and then click around the area where you want to set as the
alarm area in the image on the left side (the alarm area should be a closed area). Click the
“Stop Draw” button to stop drawing. Click the “Clear” button to delete the alarm area. Click the
“Save” button to save the settings.
4. Set the schedule of the target counting by area. The setup steps of the schedule are the
same as schedule recording setup (See 4.1.4.1. Schedule Recording Settings).
Loading ...
Loading ...
Loading ...