Loading ...
Loading ...
Loading ...
AXIS Q1604–E Network Camera
Hardware overview
15.
Bracket screws (4x)
16.
Bracket adapter
17.
Network cable (route through wall bracket)
18.
Wall bracket
19.
Bracketadjustmentscrew
Cold Startup Delay Switch
The Cold Startup Delay switch, when turned on, controls how the camera restarts after a power cut, when temperatures are below
0°C(32°F).Thecameraisfirst heated to approximately 0 °C (32 °F) before it initializes. This prevents damage to came ra parts
sensitive to sub- z ero temperatures.
Connectors
Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet (PoE).
Caution
Due to local regulations or the environmental and electrical conditions in which the product is to be used, a shielded
network cable (STP) may be appropriate or req uired. A ny network cables that are routed in outdoor environments or similar
shall be shielded (STP) and intended for their specific use. Make sure that the network switch is properly grounded. See
for regulatory requirements.
Audio in (pink) - 3.5 mm input for a mono microphone, or a line-in m ono signal (left channel is used from a stereo signal).
Audio out (green) - 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an active speaker
with a built-in amplifier. A stereo connector must be used for the audio out.
SD card slot - A standard or high-capacity SD card (not included) can be used for local recording with removable storage. For
instructions on how to insert and remove an SD card, please r efer to the Installation Guide.
Note
Before removal, the SD card should be unmounted to prevent corruption of recordings. To unmount the SD card, go to Setup
>SystemOptions>Storage>SDCardand click Unmount.
Control button - The control button is used for:
• Enabling the Focus A ssistant. Press and very quickly release the C ontrol button.
• ConnectingtoanAXISVideoHostingSystemservice.See
page 39
. To connect, press and hold the button for about
1 second until the Status LED flashes green .
• ConnectingtoAXISInternetDynamicDNSService. See
page 39
. To connect, press and hold the button for
about 3 seconds.
• Resetting the product to factory default settings. See
page 45
.
Power connec
tor - 2-pin terminal block for power input.
7
Loading ...
Loading ...
Loading ...